Electronics Forum | Wed Oct 15 03:59:00 EDT 2014 | rob
Are you using specific tooling for each part, or just generic? If so it could be pushing down at an angle and slightly tearing the PCB. We use the same style press as you but make custom fixtures to fit each connector and hold each PCB tight.
Electronics Forum | Mon Aug 22 10:30:42 EDT 2016 | emeto
Thanks for your help. We did call tech from Speedline and he got it fixed and working by exchanging just a few parts. There were a lot of custom modifications on this machine, don by who knows who and where, but the guy was very competent and fixed i
Electronics Forum | Tue Oct 09 15:15:36 EDT 2018 | jsmith01
Does anyone know of a place to get parts or repair for the Quad MV-100 Stencil printer.
Electronics Forum | Thu Oct 21 12:44:07 EDT 2010 | swag
We issue extra parts like this: 8/2 caps and resis. - 40 over 8/4 caps and resis. - 20 over 8/4 IC's - 7 over 12mm - 7 over larger feeders + stick + matrix = the correct # req'd. These #'s were based on our first SMT lines (used equip.) and we made
Electronics Forum | Wed May 09 17:49:16 EDT 2012 | dyoungquist
We run a Mydata high mix, low volume line. You can handle strips with either the Agilis feeders (losing the first 5-10 parts) or by placing the strip on the Y or tray wagons. For cheap parts like resistors, capacitors, some diodes and small ICs, ou
Electronics Forum | Thu Sep 02 17:01:30 EDT 1999 | Brian
| | Do any SMTneters out there have a good solution to substitute SMT parts that you are willing to share? I presume all of us have the issue where purchasing wants to buy "the same part" from a different vendor. While the part may be the same electr
Electronics Forum | Wed Sep 08 13:09:40 EDT 1999 | Joe Wayt
Hello: We are using a Heller 1500S reflow oven to solder surface mount parts. Just within the last two weeks, the larger I.C.'s are moving while going through the oven. The parts are checked for placement before putting into the oven. When the
Electronics Forum | Wed Jun 13 14:48:48 EDT 2007 | rgduval
Is there a sort of standard method to prevent part loss in reflow? I've had a couple of situations come up recently where we've lost some parts during second-side processing. We're running an Heller 1800, with a mesh belt. Most items process fine,
Electronics Forum | Mon Jun 18 10:11:52 EDT 2007 | dyoungquist
Almost every board/panel we build is double sided and we use an MPM SPM screen printer with no problems. The screen printer is not the cause. We have seen heavier parts fall off the first side when going through the reflow for the second side. We
Electronics Forum | Fri May 04 12:19:53 EDT 2012 | gnus
I'm guessing you're running small batches of boards on the MyDatas. We had the same issue with management when they decided to save on parts (not realizing it cost them more in time and more frustration for us). We had Agilis feeders so that helped.
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477