Electronics Forum | Wed Oct 10 02:44:47 EDT 2001 | djarvis
Frank, Don't know about point 1 but if they don't fall off I don't worry about it. If they do fall off it's generally because someone has mishandled them before the wave, like shoving them into racks and the like. If they have fallen off and you can'
Electronics Forum | Sat Oct 06 08:36:04 EDT 2001 | davef
Your point about thermosets getting soft in the preheater of the wave is well taken. But an adhesive that is used past its expiry or other up-front lack of process control represent 99 & 44/100 percent of the reason for �glued parts falling off in
Electronics Forum | Wed Oct 10 17:56:35 EDT 2001 | seand
Hello all, My respone here is to add options for evaluation for the engineer. Not to convey that they are the only options as that would be reckless. Cyberoptics does have a standard line of machines configured for in line paste inspection. Some
Electronics Forum | Fri Oct 05 16:05:58 EDT 2001 | seand
Hello everyone, Your chief variable here is going to be your epoxy. Different materials react accordingly to various inspection methods but, DEPENDING on your print parameters and material, you may be able to utilize an inline inspection machine.
Electronics Forum | Wed Dec 12 21:43:16 EST 2007 | davef
There is no specification for solder paste height, just as there is no specification for paste volume. Focus on producing a fillet that meets J-STD-001. You make the choices that produce the end result.
Electronics Forum | Fri Apr 20 16:05:17 EDT 2001 | gcs
We always reduce side to side, EXAMPLE: 12 mil width reduced to .010". Do you guys check viscosity ? Also maybe your guys are appling to much pressure on the sqweegee blades.
Electronics Forum | Fri Apr 20 15:27:00 EDT 2001 | jimlew
We do some aperture reductions - but it's not the 10% i'm accustomed to. Looks like it should be more than we currently do (I think we do 10% of length, but no width). Don't think we have a slumping problem, and we're not doing snap-off, only contact
Electronics Forum | Thu Feb 23 09:59:09 EST 2006 | SIR
We have an AUREL CS1222 machine to measure the thickness of the solder paste deposited on a bare board by a stencil printer. This device has a laser beam that has to be put on the pad where you want to measure the solder paste thickness. The measure
Electronics Forum | Thu Feb 23 13:56:21 EST 2006 | slthomas
I have dealt with it before and usually it's consistent, so you use some simple math to work around the issues. Now, if you have so much variability between different locations on your board for resist thickness, HASL thickness, etc., that it fouls
Electronics Forum | Thu Mar 17 09:34:10 EST 2005 | sumxp
What is the spec limit setting for solder paste height control in your area.Is it +/-2mils for 6 mils stencil? Tx
