Electronics Forum | Thu Feb 27 12:27:10 EST 2003 | stevel
Hi all, We got some bare pwb in our incoming inspecion looked really wrapped. The maximum twist of the pwb we messured is 0.056inch by following the method in IPC-TM-650 2.4.22 C. (The diagonal size of our pwb is 7.5inch) According to the IPC standa
Electronics Forum | Fri Nov 09 07:40:07 EST 2007 | jdumont
Thanks for all the great suggestions guys. We do not have topside heating but topside temps are where they should be before hitting the wave. No excessive copper in the area either. We are going to start with the most problematic board and use it as
Electronics Forum | Fri Mar 03 06:41:09 EST 2000 | jacqueline coia
I have tried the IPC calculator and they do not have this type of component registered. When trying to select 'other' on menu, no connection can be made. The polarity if the QFP has not been decided yet (pre-PCB design) the pitch size of the componen
Electronics Forum | Fri Mar 03 06:41:09 EST 2000 | jacqueline coia
I have tried the IPC calculator and they do not have this type of component registered. When trying to select 'other' on menu, no connection can be made. The polarity if the QFP has not been decided yet (pre-PCB design) the pitch size of the componen
Electronics Forum | Tue Apr 27 13:00:05 EDT 1999 | Justin Medernach
| What is the current spec for sizing PCB pads for a land grid array? How about for a ball grid array? Are there industry spec's I can reference? | | Thanks, | | Frank | Frank, Refer to the device manufacturers. they are going to have a recomme
Electronics Forum | Thu May 29 14:35:37 EDT 2008 | rdmundo
Gents, We've been using a round 1:1 aperture for a 5 mils thickness on our stencil design on 0402 and recently, IPC guidelines recommend oblong, homeplate or reverse homeplate. I believed the PCB pad for 0402's area within the recommended size/dimen
Electronics Forum | Fri Apr 16 13:15:17 EDT 1999 | Justin Medernach
| Hi, | I just cheesed my previous attempt at this. I looked through IPC 600 and couldn't find anything relating to dimensional stability of a board with regard to stretch. I found bow and twist but nothing on size. I have a PCB that is .030" over
Electronics Forum | Wed Nov 07 13:00:41 EST 2007 | jdumont
Hello all, we are having issues with some specific package type aluminum caps we use while running lead free. We used to run these leaded with none of these issues. Basically we are not getting more than 25% hole fill on these parts. I have tested di
Electronics Forum | Wed Nov 07 13:36:20 EST 2007 | jdumont
Hello all, we are having issues with some specific package type aluminum caps we use while running lead free. We used to run these leaded with none of these issues. Basically we are not getting more than 25% hole fill on these parts. I have tested di
Electronics Forum | Wed Oct 29 20:28:59 EST 2003 | davef
The possibilities are dizzying, aren't they? In our dingy fog, if we don't understand your requirement, say so. 3 Spec Fir Tree General Technical Specification 3a Design/Layout: IPC-2221 IPC-2222 3b PCB Fab: IPC-6011 IPC-6012 IP
IPC is the trade association for the printed wiring board and electronics assembly industries.
Training Provider / Events Organizer / Association / Non-Profit
3000 Lakeside Drive, 309 S
Bannockburn, IL USA
Phone: 847-615-7100