Electronics Forum | Wed Aug 25 17:48:08 EDT 2010 | fdr4prez
Hey, great, thanks! Now I can check with my machine maker and see what their feeders are spec'd to. I may send a reel of parts out to be tested, too.
Electronics Forum | Fri Jun 01 06:40:39 EDT 2012 | umar
Hi Norman... Thansk on yoru input, actually my adhesion test conduct is after pass of IC test. MY IC Test is shown a good result but when go into teh Test adhesion coating then during peel off test my board was failed.
Electronics Forum | Mon Aug 06 07:15:14 EDT 2012 | reypal
Hi to everyone in this forum. I came across this problem recently. Im not sure how it started and its rootcause. The chip resistor termination has been peeled off. Thanks in advance for all your advise.
Electronics Forum | Wed Jun 19 12:06:20 EDT 2013 | rgduval
We only reapplied in areas where significant wear was observed. As I mentioned, shop chairs moving back and forth, combined with lead trimmings and other debris led to scraping and peeling over time. Other than that, no, we did not re-apply over
Electronics Forum | Fri Jul 24 16:39:16 EDT 2015 | cnotebaert
have done it in the past, used silicon as it will flex,, however its not the most robust material! tends to peel/flake off.
Electronics Forum | Fri Jan 06 22:15:50 EST 2017 | sarason
Looking at your picture. Is this the first component in a reel with no tape header. If so that is your problem. Or is this a piece of cut tape that has been peeled and is sitting between a set of rails? sarason
Electronics Forum | Tue Aug 01 16:18:59 EDT 2017 | dleeper
A quick and dirty test; Take a few inches of carrier tape, peel off the cover, gently turn it upside down and see if any of the parts stay in the tape. If they do, then you know there's an issue with the tape.
Electronics Forum | Thu Mar 22 05:32:07 EDT 2018 | rob
Also, get your PCB suppliers to send you BBT failures that they would usually throw in the bin. In addition to print testing you and use them for profiling. We use a sticky film for print testing, then wipe, peel off and throw in the bin.
Electronics Forum | Tue Aug 13 10:48:17 EDT 2019 | sankarseptember
We are facing ROHM Resistor stick to top peel off tape during feeder movement. What are the possible causes and how to prevent this issue?
Electronics Forum | Thu Apr 07 15:42:29 EDT 2022 | SMTA-69080803
@ProcEng1 Yes... something like that. However, how do I ensure that the adhesive will always stay on one material assuming that the surface area is the same?