Electronics Forum | Tue Apr 09 00:26:46 EDT 2002 | craigj
Are currently investigating a change of solder paste for various reasons and are considering a move from 63/37 to using 2% silver solder paste for increased long term reliabilty of solder joints with gold finish PCBs and to further reduce reflow temp
Electronics Forum | Thu Jan 27 14:49:53 EST 2000 | Glenn Robertson
Tuan - One of the reasons I suggested pre-tinning (aside from the negative effects of Gold on appearance and reliability) is the known slower wetting of Sn/Ag and Sn/Cu alloys as compared to Sn/Pb. If you don't have to be Lead-free, the high Lead
Electronics Forum | Mon Feb 23 10:39:37 EST 1998 | Igmar
| I have been involved in SMT for only a few months so I am coming from a position of extreame ignorance. I have been asked to investigate the differences in soldering to components with Paladium coated leads vs the standard Tin_lead. I would appre
Electronics Forum | Wed Feb 25 16:39:29 EST 1998 | Eldon Sanders
I agree with Chrys, get the spike temp up and wetting is not a problem. However, when the palladium mixes in with the solder the joint will become more brittle. You need to make sure enough solder is printed on the board to minimize the concentrati
Electronics Forum | Wed Feb 25 12:55:23 EST 1998 | N.J Bateman
| | | I have been involved in SMT for only a few months so I am coming from a position of extreame ignorance. I have been asked to investigate the differences in soldering to components with Paladium coated leads vs the standard Tin_lead. I would
Electronics Forum | Wed Feb 25 12:55:15 EST 1998 | N.J Bateman
| | | I have been involved in SMT for only a few months so I am coming from a position of extreame ignorance. I have been asked to investigate the differences in soldering to components with Paladium coated leads vs the standard Tin_lead. I would
Electronics Forum | Fri May 28 17:30:35 EDT 1999 | Dave Clements
I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is about
Electronics Forum | Wed Oct 02 15:20:55 EDT 2002 | Eric
Is there a steadfast rule of thumb for a good solder joint on an Enig Gold board. I come across this number 217C when discussing BGA profiles. Is this a published number? I sure could use a reference. Anybody feedback is appreciated.
Electronics Forum | Wed Oct 02 16:13:05 EDT 2002 | babe
Have you had your solder pot tested? I find that levels of contaminants can rend a solder joint that dull look.
Electronics Forum | Fri May 28 17:44:51 EDT 1999 | Glenn Robertson
| I discovered that we have some gold plated (30 mico in.) through hole connectors which were Paste In Hole soldered (60 sec at reflow) on a HASL PCB. Do we have an embrittlement reliability issue? The calculated volume % of gold in the joints is abo
