Electronics Forum | Mon Mar 11 13:46:14 EDT 2013 | ngineer
Michelle, I've tried this, and the extra information goes away, until you save and then access the pick and place data again, then it is back.
Electronics Forum | Tue Mar 12 22:30:58 EDT 2013 | ngineer
i can only see the issue after it's uploaded to the central controller. if the sequence is edited on the HHT, from V T Pick 9 to PICK 9, it stays that way until i download to CC and go to view it.
Electronics Forum | Sat Mar 09 02:25:35 EST 2013 | ngineer
I'm setting up a rather complicated job on our quad IVc. I was almost done (after days), and after i did the sequence, i saved it, downloaded it, and started checking the picks and places, well, i needed to change one, and went back to the sequence,
Electronics Forum | Mon Mar 11 04:57:31 EDT 2013 | bobpan
You really should edit your programs in central controller where it is much easier to follow the commands shown and to follow the extent data to see whats attached to each part/pickup. The hht can quickly cause issues when the wrong button is presse
Electronics Forum | Tue Mar 12 05:01:09 EDT 2013 | bobpan
The only thing that makes sense is a problem with the program you are working on. Can you edit another program and will it save? You are seeing the same thing happen when you use the machine as and editor or central controller....this makes no sense
Electronics Forum | Tue Mar 12 09:23:52 EDT 2013 | bobpan
If you edit the sequence on the hht.....to fix your problems...you then have to upload the data to central controller. If you are not doing this....you are overwriting the data on the machine with bad data everytime you download to the machine. The l
Electronics Forum | Tue Mar 12 09:24:47 EDT 2013 | bobpan
If you edit the sequence on the hht.....to fix your problems...you then have to upload the data to central controller. If you are not doing this....you are overwriting the data on the machine with bad data everytime you download to the machine. The l
Electronics Forum | Mon Mar 11 13:27:56 EDT 2013 | ngineer
Bobpan, I have found the same, although this issue is different. If go to one of those lines in CC, and delete it, then replace it with a pick 9, then save it, i go back to the pick table, and it shows the same lead inspection electrical test, et
Electronics Forum | Tue Mar 12 07:46:26 EDT 2013 | ngineer
bobpan, It only happens with this program. CC ver 7.54, IVC V 3.05 If i leave CC out of it, and edit the sequence using the HHT, it sticks. but if i download from the assembler to CC, it's messed up. if i then fix it in CC, the minute i save
Electronics Forum | Thu Sep 05 21:31:36 EDT 2013 | nophsem
Hi: Our machine (QUAD 4C) has a CyberOptics laser 6604033; when initialize at HOME, z-rod descends and doesn't retracts, which makes me think that the laser is misaligned, here's a link to the video recording: http://www.youtube.com/watch?v=W9ma7Zsf
