Electronics Forum | Wed Sep 10 07:42:52 EDT 2008 | lloyd
Can you provide a bit more info on your machine setup. I not full fimilar with the S-27 so a few points may not be relevant to your machine. Are you using Siplace Pro. Are you using the standard GF for the 0201 component. Do you have the component
Electronics Forum | Mon Apr 19 21:37:17 EDT 2021 | ouaret
dear all, update: we got that the calibration of SIM is the problem, the distance between SIMs need to be calibrated. can someone help us get the manual that describe on how to calibrate the SIMs? we have a problem with our cyberoptics AOI machine
Electronics Forum | Tue Aug 17 11:51:52 EDT 2010 | arek
Hi, I bought Philips CSM machines (CSM66-III and CSM84V-III). I need flopy disc with some files (MCH, VIS, FDR). I created MCH file but the machine send me an error message: BAD FORMAT DATA. Could anyone help me and send me correct files. Thanks
Electronics Forum | Thu Apr 12 17:49:35 EDT 2012 | rodrigo
I've done the Fuji flush. It does the same thing. We can not load proper again because it does not communicate with either the F4G or MCS/30. I was able to boot into mechanical mode at one point but now I can not do that either. This thing is drivi
Electronics Forum | Mon Sep 22 17:02:58 EDT 2008 | hegemon
You are on the right track Ismir. Essentially however, as the programmer of the machine, I am the one that creates the PCB with the errors to benchmark the settings for the machine. No secret lab though! :-) Easy enough for most any AOI machine to
Electronics Forum | Fri Feb 11 18:59:21 EST 2005 | primus
We have been using Tape and Reel on our GSM for the SOIC-8 packages for a while, and it's working pretty well. Less operator error, less reloads, less jams (provided you take good care of the feeders) and LESS TUBES STUCK IN MY VCD SEQUENCER!!! I hav
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
Electronics Forum | Fri Jan 24 06:45:19 EST 2020 | alpha1
Depending on your equipment. If you are running stand alone equipment. Separate Sequencer and Axial Inserter there's not much you can due expect check the process. The axial should still catch at least most of the defects. If you have a combination u
Electronics Forum | Fri Nov 06 02:55:10 EST 2015 | arct1c
Hi, we are looking for 1 or 2 new postreflow AOI machines to replace our old ones and possibly 1 prereflow AOI(we never had pre reflow before). In our company we run low volumes and high volumes. I have been looking at Viscom, Mirtec mostly, Cyberop
Electronics Forum | Fri Sep 03 03:56:41 EDT 1999 | Wolfgang Busko
| We've noticed that there are many different recommendations for pad sizes for various SMT parts. This seems to vary wildly from manufacturer to manufacturer for the same case sizes. Is there any standards that can used used to specify these sizes