Electronics Forum | Sat Nov 26 05:55:04 EST 2005 | milroyperera
Hi, Does any body have the experience with wave soldering a "Gold" plated PCB with SMD assembled on it? I`m experiencing massive bridging,icicles,Shadowing & Skipping. The present soldering angle is 6 deg:,pre heating rate is 2 deg/sec , Dwell time
Electronics Forum | Fri Jan 27 17:23:10 EST 2006 | muse95
Watch the solder profiles allowed for these caps. Most electrolytics cannot withstand high heat. Even RoHS compliant Electrolytics are often rated for peak 245C, 3 secs max, for example. Nowhere close to the 260C 10-20 sec you usually like to see.
Electronics Forum | Fri May 26 10:17:21 EDT 2006 | pjc
Here are settings for a Vitronics SMR500 oven for Indium Corp. 5.1 No-Clean Pb Free solderpaste, the product profiled was of medium thermal mass: RTS, Temp C 120, 170, 195, 248, 264, conveyor speed was 43cm/min (17"/min.) Peak temps were reached in
Electronics Forum | Tue Jan 12 21:24:13 EST 2010 | graceytiu07
We have a Viscom SPI S3054QS. Yup, the machine offers a quite good speed. My board dimension is 150 by 250mm. The cycle time is only about 24 sec. The analyze time is only about 10sec. You can make your loading faster, if that's what you needed. I ha
Electronics Forum | Thu Jun 28 09:54:06 EDT 2012 | mosborne1
Dave, They rework fine. All solder joints on the whole board look great especially for lead free sac305. Here are the reflow specs: SAC305 no clean solder paste – Kester EM907 Kic thermal profiling device – 50%process window green light profile. • M
Electronics Forum | Mon Jan 21 17:59:11 EST 2013 | jorge_quijano
I had a similar situation with a very thick PCB (0.23") I could not get a TAL lower than 160 sec, I've spoken with my paste supplier about this issue and we have made some adjustments on the oven and we could lower it to 145 sec, I know it is higher
Electronics Forum | Fri Jan 13 02:54:25 EST 2017 | roblackey
When the YV100 starts up if you press a key > during its startup you can get it to ascreen > where it asks for passwords.. > > How would you > get the passwords from this Hi, if you haven't changed them then I think it's "specialist" on VIOS.
Electronics Forum | Fri Dec 27 17:13:53 EST 2019 | rhormigox
Thank you for the answers. The paste is as spec No-Clean https://www.chipquik.com/datasheets/TS391SNL50.pdf I'am writing them too. For the excessive cooking not sure, the oven sensor (that I think is about right) looks I am close to the profile, bu
Electronics Forum | Thu Nov 02 17:15:34 EST 2000 | Erdem Bilaloglu
We are using semi-circular land pattern and 0.004" smaller appertures on screen. With stable rising slope (max:2.6degC/sec)we have not experienced any tombstonning so far.
Electronics Forum | Wed Jun 21 23:47:28 EDT 2000 | gary
my topside preheat is 97 deg. C and my peak temp. is 230 deg. C with a duration of 4 secs. What would be my Delta ? I suppose 230 minus 97 is equal to 133 deg C...is that right? regards