Electronics Forum | Tue Jul 11 23:28:59 EDT 2006 | donb
Hi All, I have a continuing problem here with mis-alignment of parts on one of our Fuji CP-3 machines and I thought one of you esteemed engineering types may be able to give me a clue as to where the problem might lie. I have a Fuji trained enginee
Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Thu Jul 13 02:06:51 EDT 2006 | mika
bypass every pattern steps except 1 of them; the one step that calls for Head# 1 Now start with the first spindle on that head > for ex. no. 1 > save > load the new pattern in Dry cycle!!! > Run/Start. The reason for bypassing the fiducial check i
Electronics Forum | Sat Jun 12 16:45:48 EDT 1999 | JohnW
| | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like po
Electronics Forum | Sat Jun 12 17:41:13 EDT 1999 | JohnW
| | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like po
Electronics Forum | Tue Jun 15 16:37:17 EDT 1999 | Philip Kazmierowicz
| | | | Does anyone out there involved in RF manufacture have any experience with the KIC Slim-Kic profiler? Do you find any interference problems between the RF transmissions and the testing of your products. We build primarily high-freq stuff like
Electronics Forum | Thu Apr 13 10:05:47 EDT 2006 | daxman
Okay fellas...I posted awhile back regarding CP4 and CP6 placement issues. I think we may have figured it out. XO/YO and mark read positions were not correct. However, we have a new problem with the CP4-2. I was running the Fuji board, placing a s
Electronics Forum | Wed Nov 02 16:35:20 EDT 2016 | csm
Dear FUJI Specialist, I need your HELP, we have an CP8-42-E and machine was working properly and from one day to another when we Turn ON the machine make all the startup and check all the list, when all is ready, you have to Puch Ready and automaticl
Electronics Forum | Thu Sep 16 21:22:39 EDT 2004 | Darby
Cesar, I am not familiar with these machines but I have found that servo controller problems do not usually cause mis-placement. They tend to just stop the machine with *axis system erors. As I understand it, after you have done a return to origin,