Electronics Forum | Sun Nov 20 08:22:27 EST 2005 | stepheniii
It can also depend on the board. A board with 160 through hole BNC's requires more spacing than most boards.
Electronics Forum | Mon Jul 28 11:31:42 EDT 2008 | blnorman
Ideal situation is get a technical rep from the solder paste supplier. They know their paste better, and should be able to work out a profile based on their paste and your oven. Again, a technical rep, not the sales guy.
Electronics Forum | Mon Jul 28 16:48:54 EDT 2008 | pcbbuilders
my oven has a built in profiler, it works fairly well, but it can not predict changes. my main concern was about the time right before reflow. i know that's where the flux is activated and i was worried that i may be spending too much time at the tem
Electronics Forum | Tue Jan 31 12:13:26 EST 2006 | Calvin Kolokoy
Today's regular Sn-Pb paste chemistries are designed to run at higher peak temperatures ensuring that your lead-free alloys will coalesce with your regular Sn-Pb solder. That being said, it is do-able to solder both types in one oven. Generally, wit
Electronics Forum | Mon Aug 04 09:30:16 EDT 2008 | grics
If you have concerns, you can look at the datasheet for each component or contact one of their application or materials engineers and find out what the components are rated for...process-wise. IE, how long can I be in the oven with this part, at what
Electronics Forum | Fri Jul 25 15:54:22 EDT 2008 | pcbbuilders
I am trying to optimize my reflow profile. i have a 5 zone oven. lead-free: for the 1st 3 zones, i am good, at about 150-200 deg for 150 seconds. during the 4th zone, i am at a temp of 200-220 for 50 seconds. during the 5th zone, i am at 220-245 f
Electronics Forum | Thu Apr 22 12:27:47 EDT 2004 | barry
I placed thermo's at 2 of the problem devices. Soak (time 150 to 180) 100 sec. Time above 180 =80 secs with 208 deg. peak. The solder appeared to flow at these pads, but little to no adhesion to the joint.Total time in oven was 5 min. All other joint
Electronics Forum | Sat Apr 17 17:08:22 EDT 2004 | finepitch
Russ has a hint by saying "too long of a soak at too high of a temp or being in reflow for too long/hot". I think the board should stay in the oven for 3-4 minutes, spending 60-90 seconds of which during reflow. in order to stay in the oven for 3 m
Electronics Forum | Wed Mar 24 10:04:09 EST 2004 | Marc Apell
183C, 60 +- 15 seconds). The quesiton to use a straight ramp or soak profile comes down to the product your are soldering. The key is to get the whole assembly at the same peak temp (minimized delta) and same TAL for effective formation of the so
Electronics Forum | Wed Apr 16 16:55:38 EDT 2003 | russ
Thanks for the info, Here is a couple more questions (and you thought you were done) What size are these caps /res? how thick is your stencil? what type of oven are you using? what is the finish of the board? Anyway, it seems like (from a distance)t
