Electronics Forum | Wed Sep 10 16:09:45 EDT 2008 | vladig
To me it speaks about teh quality of the engineers. I[ve seen both types, though Vlad
Electronics Forum | Thu Sep 11 10:18:15 EDT 2008 | gregoryyork
Sorry all I know is that storing the paste Tip down the flux will run to the tip of the cartridge so will be runny initially then dry up as you use the cartridge. Unless the Rheopump mixes it before application
Electronics Forum | Thu Sep 11 10:25:51 EDT 2008 | rarnold
Flux is less dense than metal so it 'floats' to the back NOT the tip when the tubes are stored tip down.
Electronics Forum | Thu Sep 11 11:11:31 EDT 2008 | gregoryyork
Yes sorry you are right so you have answered your own question anyway. Dry to start runny at the end
Electronics Forum | Thu Sep 11 12:38:45 EDT 2008 | vladig
I'm curious how many knobs have left to be turn? :-) Isn't time an issue in a production environment? Vlad
Electronics Forum | Thu May 26 07:53:42 EDT 2022 | jojoled
Hi.Thanks for reply. 1. - I guess after JETting the paste, the head will go aside, to allow head with HD camera(SPI) to do the job.....and thus if used for AOI , the same camera will be much higher above components, not damaging anything....this is
Electronics Forum | Tue Jan 16 07:17:20 EST 2007 | adamp
I have checked pot temperature in different parts of solder pot and it looks like it is correct (250C). I have also lowered solder pot temperature and removed copper from the surface of the solder pot (operation repeated couple times). There is still
Electronics Forum | Mon Jan 15 13:38:29 EST 2007 | realchunks
Check the temp of your pot. It may be getting cooler if you can notice a difference in pump height and density. You may have lost a heater element or two. You can adjust your pot chemestry, but why would you want to if your solder sample came back
Electronics Forum | Tue Jan 16 18:13:25 EST 2007 | greg york
Try to process the composite pallet through the wave without any flux and view volume of smoke and if any residue is deposited in the wave when it exits. My guess is that the pallets are releasing some binders that are high boiling and this in turn c
Electronics Forum | Fri Jan 19 13:42:11 EST 2007 | russ
Even the level of solder in the pot can have effect on your wave height. backflow gate may have been tweaked a bit, that affects wave height, many many things affect the proper RPM required for the correct wave height. Pot may be a little lower tha