Electronics Forum | Tue Aug 09 06:21:19 EDT 2005 | bwet
Ladies and Gents: There have been several ways discussed in the trade press and in papers re: how to seperate/keep seperate Sn63 and l-f hand soldering tools. Some claim comepletel seperate hand soldering tools are required, while others claim that
Electronics Forum | Thu Apr 08 19:32:52 EDT 1999 | Tom Reilly
FYI, Yes, it is true SMT Plus [ http://www.smtplus.com/ ]does not meet IPC 782 standards but is that the goal here or to meet IPC-A-610 standards for manufacturing? I agree that patterns do cause some problems if created to maximum IPC standards but
Electronics Forum | Tue Dec 05 15:10:55 EST 2000 | Francois Monette
Victor, here are a few more elements of information to answer your question. Both the temperature and relative humidity on the manufacturing floor have a significant impact relative to the rate of diffusion of moisture inside a plastic package and t
Electronics Forum | Sun Nov 08 15:27:25 EST 2015 | davef
Thinner: Flux thinner, NOT paint thinner We kept a spare stone in thinner in inventory. We cut PVC pipe to size, cap in one end, screw thread on the other, stone inside, filled with flux thinner and covered with a screw cap. I don't remember who we
Electronics Forum | Tue Feb 01 09:53:37 EST 2005 | Howard Sommerfeld
I also have a spreadsheet tool for comparative analysis using criterion weighted scoring. It can be used to analyze any decision, and helps groups reach consensus on why a particular alternative is the way to go. As final steps you can also consider
Electronics Forum | Tue Feb 14 13:16:49 EST 2006 | Carol Stirling
CRITICAL DILEMA! Has anyone run into the problem described below and if so, what was the fix (besides not dealing with this Supplier)? Also, we do not have component manufacturing process experience. We are purchasing a surge resistor that function
Electronics Forum | Fri Jan 22 15:48:14 EST 1999 | Chrys
| Hello, | | I will be evaluating and qualifying two equipment types. The first is a fountain soldering device. I need practical advice on all the stuff you guys and gals know about as good, bad, ugly, best applications, setup, limitations, and all
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Thu Dec 16 15:00:20 EST 2004 | glaucon
Simple differences. Both processes require a very similar machine platform, controlled motion, vision fiducial recognition and alignment of a substrate (PCB or hybrid ceramic) to the "image", the image being either a stencil (hence stencil printing)
Electronics Forum | Wed Feb 25 01:24:34 EST 1998 | Steve Gregory
Dave, I confess I was a tad too general and a bit too extreme describing the way ALL solder joints look on palladium coated leads. I should been more specific about the "pillow-effect". I've seen it regularly with palladium coated leads on small SOT