Electronics Forum | Mon Apr 22 18:45:07 EDT 2002 | Steve Townsend
Chances are your profile is fine. There is probably too much paste on the descrete pads. Consider reducing the aperture size of the stencil. Good luck.
Electronics Forum | Mon Jul 28 06:13:35 EDT 2008 | cobar
Your problem is being caused by to much paste being printed.Reduce apeture size on stencil. http://www.shanelo.co.za/technical_paper_about_stencil_de.htm or http://www.shanelo.co.za/SMD%20Assist.htm
Electronics Forum | Tue Dec 29 08:11:18 EST 1998 | Kelvin Chow
As CSP and BGA packages become more and more popular, I want to know if anyone get problem to assembly CSP packages. Currently, most CSP use 20mil solder ball diameter and it is a trend to go down to 16mil or even 12mil. I wonder if there is a probl
Electronics Forum | Fri May 24 11:46:34 EDT 2002 | tmv
Lot's of good discussion in this string...but I think we've missed a few points. First off...turret machines are more than capable of handling the smaller component sizes (in fact, they are the best)...Machines like the SANYO TCM-3000 or Universal 47
Electronics Forum | Wed Apr 13 10:05:58 EDT 2016 | donnie15
I am working on soldering an Large LGA module to a PCB and am having some issues with opens due to variation in the board flatness. I have tried adding more paste but get shorts and excess flux as I get above a 7 mil stencil. I have tried adding sol
Electronics Forum | Wed Apr 14 17:39:20 EDT 1999 | Dave F
| Can someone explain the difference between solder "fines" and solder balls? Is there an official specification where "fines" are defined? What is the spec for "fines"? | | I consider "fines" individual unmelted metal spheres that are found in s
Electronics Forum | Fri Apr 23 12:26:27 EDT 1999 | Jeff Anweiler
| | I would like to known what�s MESH SIZE mean in the solder paste specification ? | | | | | Check out the thread from 4/14/99 on solder FINES vs. solder balls. The info you're looking for is in there. | "Mesh Size" is a term that is commonly use
Electronics Forum | Thu Jul 17 04:42:47 EDT 2003 | sanjeevc
Hi! One technique: 1. Remove all balls 2.Make > a mask(stensil)for reballing.The holes of the > mask must be 0.8-0.9 the size of the pads. 3. > Reball chips 4. Reflow chips Good luck Hi Yes,we have done quite a bit of reballing of BGAs with
Electronics Forum | Wed Aug 25 21:51:13 EDT 1999 | Jason Tomlinson
| Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products. Cons
Electronics Forum | Sun Jan 23 08:18:14 EST 2000 | Dave F
Jeff: I feel your pain. Your points about pin-in-paste stuff are well taken. Consider increasing the size of the pad containing the via. * Calculate volume of the finished via. * Multiply this volume by 2 to determine the volume of paste that mus
