Electronics Forum | Tue Dec 27 10:18:03 EST 2016 | anhsang38
Dear Pro, I want to confirm with you about conveyor speed. is 1m/s? We are using wave soldering but it is 1.2m/min, min not second. Pls, check it agian. The flux is not relative this error. It is relative no sodering, bridge. The solder bar is the
Electronics Forum | Tue Jan 13 22:43:11 EST 2004 | davef
We have seen this in reflowed parts, where there is flux res collected in the dimple in the solder, where the lead 'presses' in the solder. Generally, we attack this as a thermal issue: * Thermal pads sucking the heat away from the leads. * Leads no
Electronics Forum | Sat Apr 14 03:25:04 EDT 2001 | kpliew
Hi , As far as I experienced with wave reflow. If u have a refective thermal reader , u will see that the board is exposed to much more temp than the 120 deg that u set. Actually , once u see the board warp or comp. crack u should know that
Electronics Forum | Sat Apr 14 03:25:10 EDT 2001 | kpliew
Hi , As far as I experienced with wave reflow. If u have a refective thermal reader , u will see that the board is exposed to much more temp than the 120 deg that u set. Actually , once u see the board warp or comp. crack u should know that
Electronics Forum | Thu May 05 03:22:38 EDT 2005 | Hannu
I do not mean big, heavy transformers but rather small ferrite core transformers, with ferrites in the range of EF16 .. EF40. The weight of the lead and its percentage of the total weight is not the issue here. We simply do not want lead-containing t
Electronics Forum | Tue Sep 22 15:30:29 EDT 1998 | Rob Williams
| I'm looking for information on "volcano" soldering or mini-wave soldering. I need to solder a leaded device, thru-hole, on a already populated smt PCB. I want to do localized soldering on the pins of the device. | Any help would be greatly appreci
Electronics Forum | Fri Aug 24 12:24:35 EDT 2018 | davef
Could be ... Consider this: The LED and the BIG pad reflowed before the small pad. The superior force of the solder on the BIG pad pulled the LED over and the LED took the solder on the little pad along with it. Try this: Print paste on a board. No
Electronics Forum | Fri Aug 24 01:25:58 EDT 2018 | cupet
Hi everybody, please advise in case of soldering problems after the reflow soldering. The problem occurs randomly at different locations on different PCB's (not the complete surface of the board). These places are very difficult for rework. Could you
Electronics Forum | Fri Aug 24 11:58:18 EDT 2018 | cupet
Hello davef, thank you for your reply. What do you think about the footprint for the diode on the first picture where the component is not assembled? There is good wetting on one pad of footprint and the other pad has bad wetting. This problem is not
Electronics Forum | Thu Sep 26 14:06:33 EDT 2013 | kkay
We have been evaluating different solder irons and have narrowed it down to Weller and JBC. Does any one have JBC units and comments about them? This was the first time I have ever heard of JBC solder equipment