Electronics Forum | Thu Apr 06 03:17:45 EDT 2006 | Slaine
we have more of a problem with transfer of salts from skin onto the products. Oils ect can be cleaned off in our solvent based cleaning system which we put everything through, but the only way to remove salts is with warm water. And we dont use a wat
Electronics Forum | Fri Oct 18 09:27:53 EDT 2013 | dontfeedphils
I believe it's mostly worn off through cleaning solvents and the slight abrasion during the under stencil cleaning process. I couldn't say whether or not it's ever in a state that would allow it to transfer to the PCB though.
Electronics Forum | Tue Mar 09 14:23:03 EST 2010 | zanolli
Hello SMTnetters We have a unique application requiring cleaning of an aggressive OA flux. A vapor degreasing process or the immersion of the parts in boiling solvents has some process advantages over an ultrasonic aqueous process. These advantages
Electronics Forum | Mon Feb 20 13:02:22 EST 2017 | ttheis
We tried both of these suggestions and the 3-1953 is less viscous than the 3-1944 so it will flow better on the board for our conformal coating application. What cleaning solvent is recommended for cleaning off the auger parts, etc.? I haven't been
Electronics Forum | Wed May 05 06:30:40 EDT 2021 | jineshjpr
Do Proper underneath stencil cleaning. if the cleaning not effective, check Vaccuum section of the printer machine. Else change the Wipe roll. Trying out with other cleaning solvent (dedicated to stencil cleaner) also improve this issues.
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Sun May 13 21:02:34 EDT 2001 | djarvis
Gary, You're not trying to clean these boards with Iso or other solvents after using no-clean solder paste? That'll do it.
Electronics Forum | Mon Mar 31 13:51:33 EDT 2008 | gregorys
Hi! May be somebody help me with links to materials or document`s for assign separate (separate room) installation of cleaning equipment from all another SMT line. p.s. some managers of my company want to install solvent based cleaning units in same
Electronics Forum | Wed Oct 23 03:48:48 EDT 2002 | kcngoi
Hi , DEK S'pore came out with a univeral frame called 'vector',that the stencil can be removed from the frame and soak into solvent for effective cleaning. RGDS JOSEPH
Electronics Forum | Wed Sep 18 22:10:48 EDT 2002 | Joe Wong
I'm working China ,in my working factory is a electronic OEM factory and got COB and SMT. But recently, COB got a big problem because the PCB gold finger got a contamination, that make us got a most defect product. So anyone can answer me how to clea