Electronics Forum | Thu Sep 15 10:43:18 EDT 2016 | claudea2
Thanks to Bobpan we re connected our wipe system and all the air actuators work fine. I still have a problem with the cleaner fluid dispenser. It is not moving as it should to dispense the liquid when we do the command. I suspect the values in the c
Electronics Forum | Sun Mar 07 13:10:15 EST 1999 | Sam Sangani
| Has anyone used the mechanical stencil foil tensioning system from certain company that eliminates using stencil frames and epoxy & mesh? Any comments on whether it's worth looking into? We go through product revisions like we go through clean so
Electronics Forum | Fri Jan 15 08:43:43 EST 1999 | Mike McM
Bernie, If the pads are for a chip component and only about a half a pad off without anything else in the misregistered area, go ahead and use the stencil as is. Surface tension of the solder at liquidus should cause it to wick back to the pad, even
Electronics Forum | Sun May 27 19:51:00 EDT 2012 | darby
Seeing as you say you only have a small amount of cash ... I'd also consider a semi-auto printer where you align a golden board, set up the two cameras by boxing or overlaying a pad etc, and then use the vernier adjustment to get each pcb to align wi
Electronics Forum | Thu Sep 08 13:14:11 EDT 2016 | claudea2
Hello, we have an Ekra E4 that we bought used and the stencil wipe never worked. We found that the air tubing for the up (black)& down (blue) of the wipe roll is missing. There are 2 push connectors for up and 2 for down to receive the tubes. Does an
Electronics Forum | Sat May 15 03:29:35 EDT 2010 | wrongway
We used to clean our stencils by hand as well but 2005 we steped up to a ppc-n29tp stencil ultrasonic cleaner has worked great for us I would suggest a machine cleaning system it gets the stencils more clean then doing it by hand
Electronics Forum | Mon Feb 16 16:37:40 EST 2004 | adlsmt
I would try it dry first, we have never used solvents in our SPM, AP-20 or UP2000. Wipe every 4 to 10 boards. Normally dont have to wipe when using epxoy.
Electronics Forum | Mon Feb 23 13:12:55 EST 2004 | Mark
I have used MPM 3000 and Dek 265 Horizon. We always just fill them up with regular old alcohol. Cheapest and easiest way to maintain.
Electronics Forum | Fri Jan 15 09:11:28 EST 1999 | Steve Gregory
| Due to an foul up on my part, a circuit board ECO snuck up on me and I have a solder paste stencil that doesn't quite match the board. Two pads are off by about half a pad each. | | Can the solder paste stencil be modified? If so, what is the tec
Electronics Forum | Sun Feb 15 17:32:08 EST 2004 | brian bennett
i have always found any of the alcohol based solvents good.here in the uk we use the alpha make.with screen auto wipes i found the set up to be most important.i.e how many pcb's printed before wiping.i found running pcbs with bga and .50 pitch compo
