Electronics Forum | Tue Jun 16 15:00:12 EDT 1998 | Gary Simbulan
There are some common reason for capacitor cracking on my web page if you want to have a look. The document can be downloaded for your reference. | Earl, et al, | Boy things get old and cold around here fast. I promised more detail on my capactior
Electronics Forum | Mon Jun 08 15:29:17 EDT 1998 | Gary Simbulan
| Earl, et al, | Boy things get old and cold around here fast. I promised more detail on my capactior problem and I thought I could drop something completely different in the same message and tell a tale of solder balls. | First the caps. We stil
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
Electronics Forum | Mon Sep 17 09:35:08 EDT 2001 | floydl
Based on your research, what is the pad and stencil design that you recommend for 0201 assembly?
Electronics Forum | Wed Mar 12 10:26:10 EDT 2008 | realchunks
Why would a board failure related problem be a process problem. I agree most companies believe EVERY problem is a Proces Problem, but in the real world we know this is not true. A pad lifting means your solder joint was able to rip it off the boa
Electronics Forum | Wed Mar 12 23:00:10 EDT 2008 | davef
You can say: The pad was lifted after reflow and prior to the dye and pry failure analysis. When we see lifted pads, we think: * That's a good solder connection * Either it took a lot of force to lift that pad or the fabrication of the board in the
Electronics Forum | Mon Dec 19 12:21:09 EST 2005 | Amol Kane
from what i know, Tg is important from thermal stresses point of view. board warpage increases greately when Tg is exceed
Electronics Forum | Wed Aug 27 09:29:10 EDT 2008 | blnorman
I read somewhere there is a thermal measure that takes into account Tg and Td. Offhand I can't remember what it is, does anybody know what I'm talking about?
Electronics Forum | Mon Sep 17 16:03:13 EDT 2001 | jschake
The results from an experiment comparing 27 different combinations of pad dimensions concluded that the pad design with 15 mil pad length, 12 mil pad width, and 9 mil pad separation produced the best assembly yields. A 5 mil thick laser cut stencil
Electronics Forum | Tue May 26 15:39:16 EDT 2009 | mikesewell
Amkor's MLF guidelines are very similar to Actels. 1 to 1 on the stencil to part pad on the I/O pads, 75% with a grid windowpane, 0.125 mm/5 mil stencil. For example, the Actel area ratio for a 0.3 mm sq. pad and 0.125 mm stencil is 0.6 which seems