Electronics Forum | Tue May 22 10:01:19 EDT 2018 | jacson_vu
Hi All, Could you share for me inspection spec that you set up for SPI machine ? Which standard you base that? IPC or something like that. So far, my factory set up as below: Area , volume , high are: lower limit is 60%, upper limit 160% for 0201 ch
Electronics Forum | Mon Nov 16 11:09:25 EST 1998 | Don Beardsley
I'm looking for sources to purchase vacuum pick up cups used on SMT placement machines. We are an OEM supplier of I/C handlers and have a need to purchase quanties of vacuum cups for a variety of device sizes.
Electronics Forum | Thu Mar 20 12:31:47 EST 2003 | gregcr
hi all Can anyone give me a place to get touch up paint for the GSM exterior. I had the Sherwin Williams paint code but it seems I have misplaced it. Thanks for the help!
Electronics Forum | Fri Mar 18 08:50:21 EST 2005 | Bored
I usually delete segment repair files 'segrep' monthly without implications. It speeds the machine up when generating other segrep files. I believe it is just an archive for e-stop generated production files and has no bearing on management data. Hop
Electronics Forum | Mon Mar 21 21:38:40 EST 2005 | pmd
You do not need to back up segrep. This is only used for boards currently on the machine whenever the machine encounters a palm down or soft stop. It only contains what is mounted and or not mounted on that board. No System infomation is contained in
Electronics Forum | Wed Mar 13 17:13:36 EDT 2013 | isd_jwendell
On an Essemtec machine I solved my sticky tape problem by routing the cover tape different than normal so that it pulls back more instead of up. I'm not familiar with your feeders and don't know if that is even a possibility.
Electronics Forum | Tue Sep 16 17:03:34 EDT 2014 | rangarajd
We have an issue with solder wicking up the leads/ inside terminations on an SMT connector. The solder coverage is sometimes over 50% of the connectors inside pin length. The terminations are gold plated. Is there an IPC spec for acceptability? Plea
Electronics Forum | Tue Jun 09 09:04:58 EDT 2015 | lisaaci
Its not picking up the nozzle from the changer. It either doesn't at all, or leaves the nozzle partially in the changer.
Electronics Forum | Fri Feb 03 10:34:09 EST 2017 | prdmm1
PANASONIC ERJ-12ZYJ203U i am having a lot of problems picking this resistor up. i have purchased a new tool per engineering (NOT the problem). it seems the my9 is picking up then dropping it. then the machine goes to pick another and picks the dropp
Electronics Forum | Thu Mar 20 14:35:10 EST 2003 | russ
Out of curiosity why wouldn't you use sherwin williams? (french owned?) Russ