Electronics Forum | Fri Sep 03 00:17:21 EDT 1999 | JAX
You use MCS computers to transmit programs/data to machines | | --> MCSs are getting old, so you would like to use F4G or FujiCam just because you could use a standard 486/Pentium | | --> But you still like your current programming SW (obviously not
Electronics Forum | Thu May 17 05:34:19 EDT 2007 | pima
Do u use antistatic rollers inside machine? because I'm not sure that fitting anti-static bars at the entrance side of the machine will help(thats doubt even from Teknek side)
Electronics Forum | Mon Sep 17 19:40:05 EDT 2007 | davef
Ken contacted Asymtek. They stated that urethane and acrylic can be used in the same machine provided that he thoroughly flush the system with solvent.
Electronics Forum | Mon Jul 11 11:05:53 EDT 2016 | bradholland
thanks for the replies so far. So far I have been relying on the board clamp on the machine that closes when the pwb is loaded. I have also been doing these tests with double sided tape on the pwb so i can clean them off easier afterwards. I have
Electronics Forum | Mon May 16 15:22:54 EDT 2005 | Fred N
the company i work for is going into circuit boards and want to find a used wave solder machine theyre budget is 10 to 20 k i have never run one of these machines and dont no what to look for anybody out there have recommendations of what i
Electronics Forum | Tue Nov 03 18:56:22 EST 2020 | goldendragon
All, I'd like to know what a good used wave pb-free solder machine out there? Appreciates!
Electronics Forum | Wed May 16 10:37:34 EDT 2001 | davef
Similar to my response to your previous posting on this topic dated 5/8/01, things to try are: 1 Contact your non-supplier [Streckfuss] using the contact points at http://www.streckfuss.com/wave_soldering.htm, obtain source drawings for components o
Electronics Forum | Sat Aug 03 07:46:25 EDT 2019 | makersan
Hi to everyone, We want to buy an AOI machine, What are the essential features for the AOI machine? We couldn't decide between 2D and 3D, our highest component is about 2cm. The smallest case we use is 0402. Which product should we choose consideri
Electronics Forum | Wed Oct 21 01:46:57 EDT 1998 | Daniel
We currently using the Panasert SMT machine where PCB flow direction were from right to left, & we are planning to move in the FUJI -CP3 & CP4-2 in line where standard PCB flow direction were left to right. Any comment on FUJI machine modification of
Electronics Forum | Tue Feb 05 11:35:58 EST 2008 | dphilbrick
I have been using an Advantek machine for years. It is a manual load and really works good. Rarely do we have problems. When we do its because we got parts from an egineer that dumped a tube of parts out on their desk to get one part and then put the