Electronics Forum | Thu Jan 24 15:22:46 EST 2008 | gars
Just got some splicing samples. A bit worried about the brass shim getting stuck in the machine (mydata). Any help. thanks. g
Electronics Forum | Fri Jan 25 05:22:47 EST 2008 | dekiper
Hi, You could try other types without brass shim. It's also important to use a good tool that is adjusted properly. Contact me and I will help you with quality samples and instructions. http://www.dekitools.com // Per Gester
Electronics Forum | Fri Jan 25 05:28:52 EST 2008 | dekiper
Hi, I think our Splice Device is the tool yiu are looking for. It can be used in high volume production for splicing in the production line OR used to splice short lenghts of carriers to a complete reel. http://www.dekitools.com/group.asp?group=664⊂
Electronics Forum | Tue Oct 13 16:11:44 EDT 2009 | mikesewell
Not sure how many inspections need to be done at 15 - 20sec total per board, but you may need to install multiple SPIs/AOIs to hit your takt time. Mike
Electronics Forum | Tue Jan 12 15:54:09 EST 2010 | chupitoone
Hi, Orbotech actually sold it's division to ORPRO Vision. They development of the equipment is still progressing in both their Reflow inspection and SPI systems. Both have newer versions of software released and at the show in SanDiego they demonstr
Electronics Forum | Thu Mar 06 11:37:17 EST 2003 | msivigny
Hello Phil, sorry for the confusion, because of our level of defect control and tracking at each process step, we did not use AOI systems at the time. We had a manual inspection station after reflow, then ICT and Functional/Final test for each produc
Electronics Forum | Tue Mar 01 10:55:07 EST 2005 | spot
A lot depends on the complexity of the board/process as well as the amount of placements. If the board has few placements and the parts are not smaller that 0805 then doing all the rework after completion is ok. The human eye can only pick out obvi
Electronics Forum | Tue Mar 01 13:51:23 EST 2005 | pjc
pr is 100% correct, can't have visual inspectors touching up for the reason he states. I have always seen that- when in doubt they will always "touch up". Touching up is always a bad thing. Looks like you have some problems that need fixing to elimin
Electronics Forum | Thu Mar 03 11:23:50 EST 2005 | Slow Ride
Generally QC is a different deptpartment than touch-up people. Most touch-up people are just general operators, so to keep their job they always see the solder joint as "not enough". Q.C. people are generally a bit better, but know they may be call
Electronics Forum | Thu Dec 21 08:31:32 EST 2006 | Karkanov
Hi, Do you have any idea if there is some tool to inspecet if we have the right component on the board ? like a smart tweezer. Also I'm looking to find a tool to spice smt reel. I need that because our buyer told us they will only buy cut tape.
Our Company handle AOI (Auto Optical Inspection) and SPI (Solder Paste Inspection) Machines.
Equipment Dealer / Broker / Auctions
Hwaseong-si, Gyeonggi-do, Korea
Hwaseong-si, South Korea
Phone: +82-1029254936
.gif)
