Electronics Forum | Wed Sep 01 18:14:17 EDT 2010 | swag
We had that happen on rare occasions and got the live vision display back by exiting enhanced board and re-entering or by power cylcing the machine. If that does not work, I don't know how to help you.
Electronics Forum | Thu Jan 20 19:13:15 EST 2011 | jeffr
You should check that the machine actually works before you buy it. I still can purchase most parts, but the Vision Board is not available anymore.
Electronics Forum | Fri Nov 04 05:05:18 EDT 2011 | tzucury
I have a vision problem because the cam is seeing blurry, but if i manually lift the board it's starting to see more clearly, how could i fix this focus problem?
Electronics Forum | Sun Dec 21 23:30:09 EST 2014 | sarason
Since the Laser alignment bit is attached to the head and you don't have to move the part to a camera location, before placing the component on the board it is about the fastest method there is of getting accurate component alignment. With more moder
Electronics Forum | Mon Feb 12 13:09:52 EST 2018 | griinder
I see. As you say, Fid coordinates or good measurements should make it easier. 2d inspection setup at the machine may be a little more difficult. Thank you for the clarification. The Momentum's Vision is not inverted, it displays as if you are lookin
Electronics Forum | Fri May 24 03:24:14 EDT 2019 | weglimir
Thank you! it is the same on other slots as well, when I removed the board, error was the same, but it appeared instantly after DEK Program was loaded. When it is inserted - this error appears after 10 seconds (approximately) so it seems like somethi
Electronics Forum | Fri Jan 05 18:39:49 EST 2024 | madisreivik
Also, sometimes placing heads "skip" some rotation - component is little skewed on board but vision shows "correct" numbers. Probably some mechanical error ?
Electronics Forum | Wed Feb 16 05:58:12 EST 2000 | Wolfgang Busko
Hi Dane, if with "dome" is meant the irregularity of a HASL finish than we had a lot of problems especially like Dean mentioned with finepitch parts and circular fids. It ended up with cleaning the fids with erasers before using the boards. Later we
Electronics Forum | Thu Jan 27 10:22:21 EST 2000 | JAX
Dennis, Not sure why your so secrative about what machine but I guess it doesn't matter. When you start placing 0402 & 0603 packages the difference between height and width and length gets lost in tolerance. This allows the machine to pass parts t
Electronics Forum | Mon Dec 06 17:17:57 EST 1999 | Brian W.
I have not used a vision inspection system for this. We used a digital x-y coordinate measurement system. With this, we could find the center of the part and then measure where it was in relation to a fixed point, like a fiducial. Some of the syst
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723