Electronics Forum | Thu Mar 30 12:48:54 EST 2006 | krc
Pardon my ignorance on this subject but I gotta ask... When the SMT guys load partial reels, I'm told that they have to waste a few components in the process. It seemed obvious to me that there should be a kind of tape that can be added to the end
Electronics Forum | Wed Nov 26 11:53:53 EST 2014 | philc
Reckon on around 2% of wasted parts for each and every component used, and you won't be too far off. Decide on a value below which you don't care, and for parts that cost more than that, you need to keep a closer eye on them to see if they are indee
Electronics Forum | Mon Apr 15 11:40:49 EDT 2019 | cyber_wolf
To qualify the equipment for production use, you need to only do IQ, OQ. There are two parts to this. 1.) The protocol. What you are going to test. 2.) The report. Did the testing meet the spec and supporting test sample data. Example of typical
Electronics Forum | Thu Aug 17 09:06:26 EDT 2000 | Chad
We are currnetly looking at switching form squeegee's to the Dek ProFlow head system. Just looking for feedback on the performance compared to squeegee's. Also here the ProFlow reduces the amount of waste of solder paste. Can anyone reflect on these
Electronics Forum | Thu Dec 19 15:57:37 EST 2002 | gregp
Is this another case of dredgeing up 3 year old threads for shameless plugs. Check the dates guys before wasting everyones time.
Electronics Forum | Mon Jul 07 23:07:08 EDT 2003 | Vinny
Guys, Is this an old old and old one? More than a year old. You guys are wasting your time. Sorry if I am bother someone.
Electronics Forum | Fri Apr 05 15:25:14 EST 2002 | davef
Spray fluxers: Where does the excess flux [that does not glomb on the board] go after being sprayed at the board? How do various spray fluxers [wave solder machines] route �used flux� differently?
Electronics Forum | Fri Apr 19 00:02:13 EDT 2002 | abelardo
Who issued you the citation and what was the citation based on, a standard of industry, epa or who. I'm curious as well about this citation, personally never heard of such citations and I work in California.
Electronics Forum | Sat Apr 20 09:56:37 EDT 2002 | davef
look here http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=5066&mc=2
Electronics Forum | Sat Apr 20 10:00:16 EDT 2002 | davef
OSHA standards trump industry standards. OSHA can shut down your factory. The industry can not do bubkes. It's nice to following industry standards, becuase industry likes that.