Electronics Forum | Tue Nov 27 07:27:58 EST 2007 | realchunks
I'm still confused. Why reflow solder a part when you're going to wave solder it? Seems like a waste of resources and material.
Electronics Forum | Tue Oct 11 18:52:19 EDT 2016 | davef
Reflow => Top side DIP => Bottom side glue => Bottom side SMT => Wave solder ... We couldn't keep the DIP clinch apparatus away from the bottom side SMT if we did the bottom side SMT prior to DIP.
Electronics Forum | Thu Nov 19 06:20:44 EST 1998 | Kelly
| For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder a
Electronics Forum | Thu Nov 19 10:12:38 EST 1998 | Brian Conner
| For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder a
Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc
5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht
Electronics Forum | Mon Nov 23 19:34:51 EST 1998 | Mike Demos
Charles: Here are a few possibilities you might want to check: 1) Conveyor width -- if the conveyor is too tight this will cause the boards to buckle as they go through the preheat section. We recently had this happen when we changed operators. 2
Electronics Forum | Tue Nov 17 08:36:28 EST 1998 | Chrys
| For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder a
Electronics Forum | Thu Oct 07 06:02:38 EDT 1999 | Wolfgang Busko
| | | | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life
Electronics Forum | Wed Oct 06 11:58:33 EDT 1999 | Wolfgang Busko
| | | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)
Electronics Forum | Mon Dec 17 11:55:08 EST 2007 | chef
I recently had the same problems, solder bridges on every thing I made, different customers boards, etc. I wave with no-clean flux. As I sorted out problems (pin holes, blow holes, splatter, etc.) I found a lot of variable factors. I changed flux,
