Electronics Forum | Tue Apr 11 03:01:52 EDT 2017 | tsvetan
check if the top plate which is used for tray change is on it's place, also in manual mode you can see on Sig.IO page all sensors status and you can figure out which sensor is activated
Electronics Forum | Wed Aug 09 08:46:01 EDT 2017 | stivais
I agree. Just thinking.. could it be copper plating issue as well? anyway, would be interesting to see some photos. Sounds like solder (from HASL process, wave or even poorly washed SMT solder paste) to me.
Electronics Forum | Thu Aug 10 16:21:27 EDT 2017 | abruno1995
Here are some of the issues im having. 1. is the Dark Vias 2. The Excess Plating i have been talking about All input is appreciated
Electronics Forum | Fri Dec 01 15:22:46 EST 2017 | kojotssss
Recommended land and solder pattern says: VIA wall plating, via holes should be tented with solder mask on the backside and filled with solder. Solutions at this moment ? Thanks for all :)
Electronics Forum | Wed Mar 07 14:03:43 EST 2018 | junkeymonkey246
I will attach a photo of the Spec Plate. NO:6241b10465-8-41941603
Electronics Forum | Thu Aug 30 12:31:26 EDT 2018 | emeto
We all agree that you have a PCB issue. It would be for the best if you use a lab to investigate a few of these PCBs. It would be interesting to investigate the plating specs and contamination levels. For a start you should insist on proper packaging
Electronics Forum | Mon Sep 17 12:21:43 EDT 2018 | bpeay
M_, the parts may be similar but the boards look to be different. Is the thermal relief for each lead on each board the same? what is the board finish, HASL, Enig, OSP or other? The part itself may not be your problem but the part that is partial pla
Electronics Forum | Mon Sep 17 06:45:56 EDT 2018 | mk15
hello, Does anyone know about the value of components ˇDIODE AND REZISTORˇ near MOSFET transistor Q13 IRF840 on the board Mydata Plate K-029-0016 Elmo Power. Thanks
Electronics Forum | Thu Sep 27 10:13:31 EDT 2018 | dontfeedphils
This should help out. You should have a fairly large calibration plate to use during this process as well.
Electronics Forum | Fri Oct 26 12:29:22 EDT 2018 | davef
I'm not aware of a standard requirement. One screw hole diameter seems to used commonly.