Solder Preforms

Subscribe to Thread

Anyone use these for soldering through-hole components? Our ... - Aug 02, 2006 by

Lawrence, I can help you offline for any connector thru-h... - Aug 03, 2006 by Jim Z

We used to do point to point through hole soldering with rob... - Aug 03, 2006 by Rob

pre forms at least in my experience have been very cumbersom... - Aug 03, 2006 by RDR

Lawrence

#43150

Solder Preforms | 2 August, 2006

Anyone use these for soldering through-hole components? Our comapny is contemplating several options such as preforms,capital equipment like spot soldering equipment and the intrusive reflow system. We are in the process of deciding which strategy we will use.

reply »

Jim Z

#43153

Solder Preforms | 3 August, 2006

Lawrence,

I can help you offline for any connector thru-hole soldering requirements.

Jim Zanolli www.tekais.com zanolli@tekais.com 401-785-4110

reply »

Rob

#43154

Solder Preforms | 3 August, 2006

We used to do point to point through hole soldering with robots. OK for medium to large volumes, but we did have to develop customer holders for each product.

Quality was good - every joint was programmable for tinning, preheat, temperature etc, and it worked out that 3 robots were about the speed of 2 operators - but could run 24 hours.

reply »

RDR

#43164

Solder Preforms | 3 August, 2006

pre forms at least in my experience have been very cumbersome and expensive. in both piece part price and labor to install.

If possible have the preforms installed on your widget prior to buying

Russ

reply »