SMT PARTS FEEDERS

Subscribe to Thread

I am having a lot of problems trying to Identify feeders nee... - Jan 31, 2001 by chugarth

The size of a feeder is determined by the width of the carri... - Jan 31, 2001 by CAL

There is a lot of good information on the topline website at... - Feb 01, 2001 by RMc

Where can I find any manual in the internet for drill CNC LE... - Feb 14, 2001 by

chugarth

#5108

SMT PARTS FEEDERS | 31 January, 2001

I am having a lot of problems trying to Identify feeders needed to place parts from a Quad Mach. How do I find out what parts such as SOD 123 what feeders do they use.etc 8mm,12mm, etc. Do any parts suppliers furnish good information

reply »

CAL

#5110

SMT PARTS FEEDERS | 31 January, 2001

The size of a feeder is determined by the width of the carrier tape the components come in. i.e. If you measure the width of the tape with a precision ruler or calipers that measurement will be the feeder size. Also, when you order parts the tape size should be specified thus indicating the feeder size needed.Who ever within your company is ordering parts, they should have or can get the tape size information. A lot of the Placement equipment manufacturers have a generic component library set up with this information.

If this does not answer your question, please elaborate a little more. Cal

reply »

RMc

#5121

SMT PARTS FEEDERS | 1 February, 2001

There is a lot of good information on the topline website at http://www.toplinedummy.com/catalog.cfm.

reply »

maria

#5233

SMT PARTS FEEDERS | 14 February, 2001

Where can I find any manual in the internet for drill CNC LENZ ?Where can I find information for new drills CNC

reply »