Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Electrovert Omni 7

Views: 3860

#60003

Electrovert Omni 7 | 28 September, 2009

I need help with conveyor speed in Omni Excel 7. It fluctuate, and never have a steady speed. I swapped the speed control card,calibrated, encoder, and I still have the same problem. Any help would be appreciated, thanks.

reply »

#60010

Electrovert Omni 7 | 29 September, 2009

Does it ramp up and dowm or do you get a jerk in the conveyor every so often? Jerk in the chain is a sticky link in the chain. Lube may work but if really bad needs replacement.

reply »

#60013

Electrovert Omni 7 | 29 September, 2009

The electronics degrade over time and you get troubles like you're having and you need to install a "noise reduction kit". Basically it's a new interface card set and some cables. You might call Speedline and ask tech. support if this is something you should try if you can't find any problems.

reply »

#60014

Electrovert Omni 7 | 29 September, 2009

Thank you for responding. I called Speedline tech support he think there is a short some where in the motor. I changed the motor out and still have the same problem. The chain is normal, and using automatic lubricating. I will check more into this, and will post if anything come up.

reply »

#60061

Electrovert Omni 7 | 7 October, 2009

> Thank you for responding. I called Speedline tech > support he think there is a short some where in > the motor. I changed the motor out and still have > the same problem. The chain is normal, and using > automatic lubricating. I will check more into > this, and will post if anything come up.

Found the problem, faulty encoder or conveyor speed sensor.

reply »

Manufacturing Software

Jade Series Selective Soldering Machines