Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.

Matrix Tray Setup

Views: 4805


Matrix Tray Setup | 30 December, 2009

I'm setting up a matrix tray for the first time on our Quad QSP-2.

I believe I have defined the tray and holder. Assigned part numbers. My issue is that instead of teach feeders, I think I need to teach table top. When I do this, I am not finding any area in the software to verify correct spacing and do any pick up verifies.

If anyone could shed some light on this issue, I greatly appreciate it.

Thanks, Craig

reply »


Matrix Tray Setup | 30 December, 2009

Craig -

It has been quite a while but from what I remember you teach the tray holder in teach table top. Then you have to put the part/tray on the the tray holder. Also, ensure the part is in your program.

I don't remember where to do that but I do know you will not be able to teach/verify the pickup in teach tabletop.

Maybe that will help you until some of the Quad pros return from the break it seems that most companies are on.

Good Luck and Happy New Year!

reply »


Matrix Tray Setup | 30 December, 2009

Craig: Make sure you have done a table changeover and then when you go into teach tabletop there should be a tab at the top that says matrix trays. After selecting that ...choose the tray you want below and then right click on a part on the tray in the graphics and make it your reference 1 part. Teach it and then step through the tray making sure its stepping correctly...... good luck Bob

reply »


Matrix Tray Setup | 31 December, 2009

Thank you very much for the input. I figured out my problem to be that once I defined the tray, I did not changeover the table top just as Bob said.

I'm good to go now, I think anyways. I was so used to the IQ feeders, changing over the matrix tray slipped my mind.

Thanks again, and happy new year to all!


reply »

Industry 4.0 Reflow Oven

best reflow oven