> I recently wrote a program on one of our > Pilarhouse Jade machines and receiving an error. > The machine has the feature of "Wave Height" that > I don't have enabled for a 2.5mm extended tip > nozzle. This is the only program that I haven't > used this feature. So what it does is this... the > first board you run it does the solder bath > height check, fluxes board, solders board, and > goes home. You load the second board, hit start, > it fluxes, then shows a "Reserved" error on the > log. You can stop the program, start it, and it > will run fine for that one run but when you load > another board the error pops up again. I've > tought the nozzle for "wave height" and enabled > it and it still shows an error. > > Any ideas??
Just re wrote the program exactly with no error. Confused...
reply »