Quad IVC Motor Error 4

Subscribe to Thread

I am seeing a motor error 4 intermittently during operation.... - Jun 30, 2011 by Jay

x and y ribbon cables would be my first guess...... good ... - Jun 30, 2011 by bobpan

bought the cable replacement kit and replaced all of the rib... - Jul 06, 2011 by Jay

i have seen bad motor cables cause the problem......you can ... - Jul 06, 2011 by bobpan

Jay

#64580

Quad IVC Motor Error 4 | 30 June, 2011

I am seeing a motor error 4 intermittently during operation. Sometimes it happens as soon as a program starts, sometimes it will perform 1-6 placements and then stop with it. I have swapped the stepper motor driver cards, the EPCU card, the SRX card with known good cards and still have the error. I have checked the motor cables and windings and don't seem to have a problem there. Anyone had this problem or seen one similar to it?

reply »

bobpan

#64581

Quad IVC Motor Error 4 | 30 June, 2011

x and y ribbon cables would be my first guess......

good luck

reply »

Jay

#64592

Quad IVC Motor Error 4 | 6 July, 2011

bought the cable replacement kit and replaced all of the ribbon cables and still the deadly motor error 4. Everything in the system has been replaced except the X motor and the Y motor cable.

reply »

bobpan

#64593

Quad IVC Motor Error 4 | 6 July, 2011

i have seen bad motor cables cause the problem......you can ohm them out to the driver cards or if you have extras....replace them

Bob

reply »