Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Wide or Narrow view?

Views: 4598

#65612

Wide or Narrow view? | 8 December, 2011

Hello every one! How I know if camera 1 and 2 are Narrow or Wide view in a Fuji IP3?

reply »

#65703

Wide or Narrow view? | 3 January, 2012

Hi Comando,

Wide view or narrow view depends on how the camera is positioned on the mounting bracket, and which lens is attached to the camera. The narrow view is mounted higher on the bracket. The wide view is mounted lower.

Can you explain a bit more?

reply »

#65704

Wide or Narrow view? | 3 January, 2012

Ok, I'm technical at Napco Security System production factory Dom. Rep. there are 13 line with CP43, IP2, IP3, GL5 etc. Camera #2 don't work at one IP3 and We can't pay Fuji specialist but we have to calibrate it, I chane the camera but i don't know it camera 2 is narrow or wide, now I know it is a Narrow view because is mounted higher, and what about resolution?

reply »

#65705

Wide or Narrow view? | 3 January, 2012

Hi comando,

If you change a camera, there are quite a lot of calibrations you need to carry out. Firstly: Did you remove the camera from the mounting bracket? If so, you'll need a special jig to mount it back on the bracket properly. You can still do it without the jig, but it's time consuming, and you need a lot of tools.

If you haven't removed the cameras from the brackets, you will need to perform a resolution calibration, camera center calibration, and finally a placement accuracy calibration. To do this, you will need an accurate dial gauge, a magnetic base, a nozzle resolution jig, and a glass PCB with glass parts. Do you have these?

Thanks, Daxton

reply »

#65707

Wide or Narrow view? | 3 January, 2012

Yes I have this tools and jigs but I can't to complete first calibation (Image camera Y Adjustment) I done all and the nozzle is in the center of display but the machine don't perform this calibration. the nozzle image in display look litle big than others machine on this. what do you recommended

reply »

#65709

Wide or Narrow view? | 3 January, 2012

Hi, Click on my name to send me an email, or provide me with your email address. Once I have your email address, I will send you the detailed calibration instructions.

Thanks, Dax

reply »

#65730

Wide or Narrow view? | 10 January, 2012

I sent you several emails and have not heard a reply. Did you receive everything I sent? Were you able to get the machine working?

Thanks, Dax

reply »

Fluid Dispensing Aerospace

IPC Training & Certification - Blackfox