Electrovert omniflow 10 speed control fail

Subscribe to Thread

Hi i working now on electrovert omniflow 10 tha deos not con... - Apr 24, 2013 by SMTVYS

If your current problem with the conveyor speed was caused b... - Apr 29, 2013 by MPMENG

SMTVYS

#68732

Electrovert omniflow 10 speed control fail | 24 April, 2013

Hi i working now on electrovert omniflow 10 tha deos not control the speed of the conveyor on the sofware, i did change the encoder but this ones continue failing, this fail start because we have a short cut on smemma wire, any one have experience with that before

reply »

MPMENG

#68761

Electrovert omniflow 10 speed control fail | 29 April, 2013

If your current problem with the conveyor speed was caused by the SMEMA issue, maybe you have a Board #1 problem. The SMEMA communicates to the computer through Board #1. The input signal from the speed encoder and the output analog voltage to the speed control card also pass through Baord #1.

I am wondering if you checked for 5VDC source to the encoder? Also did you try to adjust/calibrate the conveyor speed control?

reply »