Mirae 1010 problem

Subscribe to Thread

I have a Mirae 1010 and am getting the message "FPGA 1 bad o... - Nov 06, 2013 by RLM

The key to figuring out mirae machine failures 'most of the ... - Nov 06, 2013 by bobpan

Thanks Bob, Any idea on how to switch between the front &... - Nov 06, 2013 by RLM

I believe but am not 100% sure on this but usually just hi... - Nov 07, 2013 by bobpan

RLM

#71335

Mirae 1010 problem | 6 November, 2013

I have a Mirae 1010 and am getting the message "FPGA 1 bad or illegal" upon initilization. Has anyone ever come across this message ? If I reboot several times I can get the machine started.

Thanks

reply »

bobpan

#71337

Mirae 1010 problem | 6 November, 2013

The key to figuring out mirae machine failures 'most of the time' is found in mr-terminal. Is this message from mr-terminal or is this the windows/program software error. Mirae 1010 machines have boot failure problems often. Sometimes if the z position of the heads is not the correct height (meaning too high or low) it wont boot. Also if the gantries are not located in a certain area of the machine they will not boot. Just some food for thought.

Good Luck

reply »

RLM

#71340

Mirae 1010 problem | 6 November, 2013

Thanks Bob,

Any idea on how to switch between the front & back monitor/keyboard. This machine doesn't have a front/back switch like my other one. i am guessing that there is a keyboard sequence that i need to hit.

reply »

bobpan

#71343

Mirae 1010 problem | 7 November, 2013

I believe but am not 100% sure on this but usually just hitting any key will change which monitor/keyboard is being used. I know for sure on the newer models it works this way. There should be a hub in the machine where keyboards/mouse/monitors run to.

reply »

SMTnet
»
Electronics Forum
»
Mirae 1010 problem

Dispense micro volume solder paste and conductive adhesive down to 150µm. Watch solder paste dispenser in action.

High Resolution Fast Speed Industrial Cameras.

Use Thermal Imaging to enhance your Underfill process.