ERSA Ecoselect 2 Clamp Rails

Subscribe to Thread

Hi, Can somebody confirm the correct operation of the r... - Nov 27, 2013 by processman

You can have it either way. In each program you can select ... - Dec 03, 2013 by Chad

Just to add to Chad's response, there is box that you need t... - Dec 12, 2013 by Dback

processman

#71442

ERSA Ecoselect 2 Clamp Rails | 27 November, 2013

Hi, Can somebody confirm the correct operation of the rear clamp rails on an Ersa Ecoselect 2.... Do they only activate when the PCB comes into the machine then release, or stay activated thru out the flusing, heating, soldering etc

reply »

Chad

#71455

ERSA Ecoselect 2 Clamp Rails | 3 December, 2013

You can have it either way. In each program you can select to have the side pressure active for the entire program. The factory setting is to have it release immediately after it pushes the pcb against the fixed rail.

reply »

Dback

#71482

ERSA Ecoselect 2 Clamp Rails | 12 December, 2013

Just to add to Chad's response, there is box that you need to check in the program editor, ours is under the colum soldering unit one, click on the icon at the bottom, you should now be able to see a box " fix horizontal permanently". Check this box and this will clamp your pcb while is being sodered.

We use it on every program. So just before we run, we just take a quick look and makes sure this box is checked.

reply »