Buying 1 or 2 Post reflow AOI and 1 Pre reflow AOI

Subscribe to Thread

Hi, we are looking for 1 or 2 new postreflow AOI machines to... - Nov 06, 2015 by RedChili

Good Morning RedChilli, I have worked with Mirtec for qui... - Nov 06, 2015 by CL

Good morning RedChili, This is Marvin from Saki America.... - Nov 10, 2015 by SAKI-AM

RedChili

#74835

Buying 1 or 2 Post reflow AOI and 1 Pre reflow AOI | 6 November, 2015

Hi, we are looking for 1 or 2 new postreflow AOI machines to replace our old ones and possibly 1 prereflow AOI(we never had pre reflow before). In our company we run low volumes and high volumes.

I have been looking at Viscom, Mirtec mostly, Cyberoptics, Koh Young, Saki, Omron and we are looking for 2d/3d AOI.

I would like to know more about these names i mentioned and your experience with their AOI. Feel free to recommend any AOI but I would like to know why you recommend this product.

reply »

#74836

Buying 1 or 2 Post reflow AOI and 1 Pre reflow AOI | 6 November, 2015

Good Morning RedChilli,

I have worked with Mirtec for quite a few years. I have looked at some of the other machines mentioned but have no practical experience with them. I started with the Mirtec MV-2 (long ago)due to the success of this platform, we upgraded to the MV-3. I have used the MV-3 platform for over 10 years. This is a 2D system. I successfully used this platform for 1st piece (pre-Reflow) and post reflow SMT inspection. This is a split axis machine. I did find a need to slow the table speed down for wet paste inspection to avoid shuttling the board and displacing components. My last upgrade on the MV-3 was to the 45mm clearance machine (standard now) I was able to utilize this for through hole inspection as well. I have recently upgraded to the MV-6 Omni 2D/3D in line. This is a gantry machine so wet paste should not be an issue. We are still in the process of implementation but I have full confidence in Mirtec. Over the years, any issue that was identified (was usually of my own doing) was immediately addressed and resolved. I cannot give Mirtec a higher recommendation. Their platforms have been reliable and their support has been phenomenal. 15 years and counting, they have not let me down.

Good Luck with your eval.

Thanks

Christopher Lampron

reply »

SAKI-AM

#74858

Buying 1 or 2 Post reflow AOI and 1 Pre reflow AOI | 10 November, 2015

Good morning RedChili,

This is Marvin from Saki America. I came across your post and I noticed that you are interested on 3D-AOI and 2D-AOI machines. We can offer pre-reflow and post-reflow full 3D-AOI and 2D-AOI for you needs. IF you have any questions regarding our machines you can contact me directly at marvin.larin@sakicorp.com for more details. You can also call us at 510-556-6459 (Cell) or at our office at 510-623-7254. We are located at 48016 Fremont Blvd, Fremont, CA 94538.

Best regards

reply »