Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


preparing Quad QSP 2+ for shipping need advice

Views: 2012

#79133

preparing Quad QSP 2+ for shipping need advice | 6 October, 2017

In order to ensure that the machine arrives undamaged; what do we need to do?

reply »

#79136

preparing Quad QSP 2+ for shipping need advice | 7 October, 2017

1. Secure all linear bearings to not move during the transport 2. Wrap the machine completely with stretch folio to protect from dust and moisture 3. Attach shock sensor to it so when it arrive you can see if it was subject to harsh transport

reply »

#79140

preparing Quad QSP 2+ for shipping need advice | 7 October, 2017

Many Thanks

reply »

#79147

preparing Quad QSP 2+ for shipping need advice | 9 October, 2017

Hello Joyce, Usually I use Very Large cable ties and secure the heads in the opposite corners. I also tie up the z rods or put some plastic tube under the top portion to keep them up. Remove the monitor and bracket off the side of the machine...and if you place it in the bottom of the machine...make sure you plastic wrap it so that it doesn't move. If you ship feeders with it....you take a chance if you just latch them into the feeder bases....if you cant wrap them down...I would box them and put them in the bottom of the machine also.

good luck

reply »

#79150

preparing Quad QSP 2+ for shipping need advice | 9 October, 2017

Thank you - we will follow your directions.

reply »

Industry 4.0 Reflow Oven

Flexible high speed pick & Place