Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Philips Topaz X change nozzle FNC

Views: 2625

#79489

Philips Topaz X change nozzle FNC | 15 December, 2017

I have one Topaz X FNC machine with this problem. The head 2 FNC not change the nozzle. The head 4-6-8 is ok and change, but head 2 no, when he tries to change the nozzle he gives me an error message. What could be the problem?

reply »

#81343

Philips Topaz X change nozzle FNC | 31 October, 2018

Check optical head height sensors.

reply »

#81393

Philips Topaz X change nozzle FNC | 8 November, 2018

If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and gets stuck midway and hence the error, then you need to align R axis for this particular head so that the clutch can engage properly.

reply »

SMT Custom Nozzles

used pcb assembly equipment - lel semi