DEK265 GSX chase clamp error

Subscribe to Thread

Hello everyone, on one of my DEK machines chase clamp is ... - May 29, 2018 by bukas

So when it aligns (or attempts to) chase clamps stay on and ... - Jun 04, 2018 by DEKHEAD

correct, I also tried swapping motherboard but still same re... - Jun 04, 2018 by bukas

I have seen battery leakage damage traces on MINT cards... S... - Jun 04, 2018 by DEKHEAD

sadly no, I can't open cmd since system doesn't come up, seg... - Jun 05, 2018 by bukas

problem was solved by cleaning lid bolt connector on chassis... - Jul 16, 2018 by bukas

bukas

#80479

DEK265 GSX chase clamp error | 29 May, 2018

Hello everyone,

on one of my DEK machines chase clamp is always ON. I couldn't find system setting to change this. already tried swapping hard drive, swapping PCIB40#1, swapping SCB34x1. In diagnostics > screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and stencil is aligned. Did anyone have similar experience?

reply »

DEKHEAD

#80495

DEK265 GSX chase clamp error | 4 June, 2018

So when it aligns (or attempts to) chase clamps stay on and prevent / resist chase movement with actuators =>>> mis-alignment?

reply »

bukas

#80496

DEK265 GSX chase clamp error | 4 June, 2018

correct, I also tried swapping motherboard but still same result. i the mean time i found battery leakage on Eurosys X1, replaced battery but now it won't start communication on machine initialization. got to repair it or something...

reply »

DEKHEAD

#80497

DEK265 GSX chase clamp error | 4 June, 2018

I have seen battery leakage damage traces on MINT cards... Since you indicate failure on machine initialization, assume you are able to communicate / accomplish MINT download. (?)

reply »

bukas

#80501

DEK265 GSX chase clamp error | 5 June, 2018

sadly no, I can't open cmd since system doesn't come up, segment display on card shows .L and 8 blinking

reply »

bukas

#80674

DEK265 GSX chase clamp error | 16 July, 2018

problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card behaved the same way.

reply »