Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


MIRAE

Views: 440

#82398

MIRAE | 23 April, 2019

Good morning guys, calibrating the cameras in smt machines Mirae mx200l and mx200lp, anyone know?

reply »

#82425

MIRAE | 24 April, 2019

You need two calibration jigs to calibrate these cameras. There is an L-Type align offset jig that involves removing the front feeder base, and placing the target dot over the middle camera of your front camera bank. After this calibration is done, there are special nozzles with white circles that go on the heads to perform the head offset calibration. Attached is a procedure to give you an idea. Both of these procedures must be done, and in correct order, for a proper calibration. Without these calibration jigs, the only other option would be to manually manipulate the head offset numbers in MSetup. If you attempt this, be sure to write down your original numbers.

Attachments:

reply »

#82426

MIRAE | 24 April, 2019

Here is a newer procedure I found, that is more in depth with better illustration. The nozzle jig, is also used for proper Z calibration, and is pictured in this service procedure.

Attachments:

reply »

#82428

MIRAE | 24 April, 2019

HI Griinder, thank you very much your help, my compliments.

reply »

#82431

MIRAE | 24 April, 2019

Here is the one for the MX series. The others were for MPS series. They are generally the same, but just in case you do proceed with the jigs, follow this procedure.

Attachments:

reply »

Electronics Experts Needed - Contract Jobs - We have Electronics Auditor positions available now!

SMT Custom Nozzles

PCB Rework / Repair Services