Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Dek 248 Table out error

Views: 2386

#82783

Dek 248 Table out error | 12 June, 2019

We have a Dek 248 that when the table goes in it will not come out. We tested up/down sensors they are fine. The in and out sensors work in diagnostic. when we try to abort the unit the table should come out but doesn't. Any help would be great and a big help.

reply »

#82823

Dek 248 Table out error | 13 June, 2019

Does it cycle in/out in diagnostics? Have you checked pneumatics to to the RS cylinder?

reply »

#82840

Dek 248 Table out error | 19 June, 2019

We have been looking at the Sol for the in and out and the up and down for the blades. We moved the sol around with no change. where is the RS cylinder located in the DEK 248.

reply »

#82845

Dek 248 Table out error | 19 June, 2019

Is the signal making it to the SOL? Is it toggling when signal is present? RS Cylinder is to the rear of the RS rails.

reply »

#82848

Dek 248 Table out error | 20 June, 2019

Would you happen to have a picture of the RS Cylinder and Rs rail. When we send the table in sol 4 is on. When we try to send the table out sol 4 and 5 are on. We are having a hard time finding the RS Cylinder and RS rail

reply »

#82910

Dek 248 Table out error | 27 June, 2019

Good news we fixed the unit. The air pressure for the RS was not off. made a small adjustment for the in and the out. unit working fine.

reply »

#83021

Dek 248 Table out error | 18 July, 2019

I guess you were able to locate the RS cylinder. Assuming adjustments to RS flow controls was your resolution.

reply »

Capillary Underfill process

IPC Training & Certification - Blackfox