Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Tape covers on component reels sticking on samsung feeders

Views: 1498


SMTA-David

#82831

Tape covers on component reels sticking on samsung feeders | 18 June, 2019

Hi, I have an older Samsung pick and place (CP-40LV model). During last few runs I have experienced several feeders with the clear plastic tape cover not peeling back to expose the next part. I manually pull back the tape and it runs for a while and then happens again. Could this be due to an issue with the reels (old stock or poorly reeled parts)? or is this more likely a problem with the feeders themselves? If the feeders, could you give me some ideas what to look for to adjust, fix or replace?

Thanks

This message was posted via the Electronics Forum @ SMTASMTA

reply »

#82833

Tape covers on component reels sticking on samsung feeders | 19 June, 2019

The few timeds this happened to me, it was taken care of by cleaning the feeder thoroughly. Be sure to check moving part for damage.

reply »

#82863

Tape covers on component reels sticking on samsung feeders | 23 June, 2019

Some manufacturers put very strong glue, the wider the part is so increases the glue strength. May sound funny but the only thing that worked was attaching a fishing weight to the tape, need to play a little until you find the correct size. The only problem is that someone needs to watch and raise the weight when it reaches the floor. We have a different annoying problem with some manufacturers, mainly LED - the parts stick to the tape. So far we have no solution for this.

reply »

SMT fluid dispensing

SMT Machines china