Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Single-view camera in Topaz-X and connector type element

Views: 833

#83640

Single-view camera in Topaz-X and connector type element | 23 October, 2019

I have a single-view camera on a Topaz-X machine. When I define a connector type element - it displays messages like in attached files. If I change the type to IC - no problem. There is also no problem when "learning" the element, checking recognition, etc. - only when entering into the program and when trying to start the assembly process or optimization. Changing the type to IC (without changing other parameters) removes the problem. Someone can suggest something? I suspect machine configuration ...

Attachments:

reply »

#83716

Single-view camera in Topaz-X and connector type element | 9 November, 2019

I suspect configuration too. From memory, only certain heads are assignable as 'Fine'. Changing this parameter in the component data to Standard or QFP will most likely cure this as any head will accept those two options

reply »

#83720

Single-view camera in Topaz-X and connector type element | 10 November, 2019

It turned out that only SF heads support "fine" mode, while FNC does not. Probably because above the FNC nozzle there is a "circle" rotating the nozzles, and in fine mode it can interfere with the reflection of the camera light - the element is lowered and also illuminated from the side.

reply »

Small Parts Tips

Facility Closure