Sticky Pressure sealed tape used with Mycronics Agilis feeders

Subscribe to Thread

Does anyone else have issues of certain cover tape that gets... - Feb 27, 2020 by MM

This happens with either old tape, the cover tape doesn't st... - Feb 27, 2020 by SMTA-Alex SMTA

#84570

Sticky Pressure sealed tape used with Mycronics Agilis feeders | 27 February, 2020

Does anyone else have issues of certain cover tape that gets stuck in and around the feeders? I have been fighting these 2 tapes all day. I try to tape them to the pocket tape with a twist, but it only works so long. It happens Either because its sticky or Peel is too thick and does not want to stay to the left of the feeder? Any suggestions?

reply »

SMTA-Alex

#84571

Sticky Pressure sealed tape used with Mycronics Agilis feeders | 27 February, 2020

This happens with either old tape, the cover tape doesn't stay sealed on the left side, or is the seal is too far to the right, the knife lifts the cover tape. There isn't much you can do in this case. Your choices are: switch the component into an Agilis Flex feeder or an old-style TM magazine, or to continue taping the peeled cover tape by the end of the Agilis feeder every few boards.

This message was posted via the Electronics Forum @ SMTA SMTA