Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Placing components by board instead of per block

Views: 1868

#84888

Placing components by board instead of per block (Assembleon) | 20 May, 2020

My Assembleon Emerald Xii runs its production block by block instead of board by board, this causes a lot of nozzle switches.

If you have a board with 6 blocks present, is it possible to finish all the mounts on all blocks of a certain component before moving on to the next component.

Even executing the process mount per mount, but then on all 6 blocks would be a great help.

reply »

#84890

Placing components by board instead of per block (Assembleon) | 20 May, 2020

This is what data optimization is for - I don't know how in Xii, in Topaz-X is in the DATA_GENERATOR menu. Do you have a manual?

Attachments:

reply »

#84907

Placing components by board instead of per block (Assembleon) | 22 May, 2020

No i dont have a manual for a Assembleon Emerald, if anyone can find one that would be a big help!

also when i open the Optimizer there are very limited things i can do with it, i can tell it to have feeders in set position and tell it where to prioritize feeders. thats it, and when executing the optimization it will just say results: ok

reply »

#84908

Placing components by board instead of per block (Assembleon) | 22 May, 2020

Is Topaz-Xii or Emerald? Write, I'll check what I have in the evening. Send me e-mail address.

reply »

#84909

Placing components by board instead of per block (Assembleon) | 22 May, 2020

Its a Assembleon Emerald Xii.

Thank you very much.

I wil private message you my email

reply »

#84914

Placing components by board instead of per block (Assembleon) | 22 May, 2020

Give me your address or write zaopatrzenie@compit.pl

reply »

#84952

Placing components by board instead of per block (Assembleon) | 8 June, 2020

Since it is an Emerald XII, I suppose it is Windows and not VIOS. Go to Optimize and select "Convert with Note Data". This will convert all blocks to single PCB and keep a NOTE of original Block Data so that you can convert back to block if and when needed.

reply »

#84955

Placing components by board instead of per block (Assembleon) | 8 June, 2020

yes!

this is what i was looking for, i figured it out today with the help of Michal who gave my 2 manuals.

thank you very much for you're respond's.

for the order that i just ran it gave me over 10% faster runspeed

reply »

Panasonic CM402, CM602, DT401

FPC* - Fluid Pressure Control - Dispensing Pump