Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


QUAD IVC Pickup Problem on Z Axis

Views: 2030

#84950

QUAD IVC Pickup Problem on Z Axis | 7 June, 2020

Hi, I went to run my IVC yesterday and it got a Motor Error on first pickup. Pressing Enter showed Z:-27:0 So according to the manual that means the Zaxis was commanded to go to -27, but the limit is '0'. I tried a Function 3 on that pickup and the Z parameter is in the 950 range. That is normal for this instrument. I tried teaching a pickup from scratch, and again, the Z parameter was as expected, approx 950. But when you do a 'Run Step' it suddenly thinks the Z param is -27. Any ideas on why the database says ~950, then the rod is commanded to -27?

reply »

#84951

QUAD IVC Pickup Problem on Z Axis | 7 June, 2020

email me and i will guide you through the troubleshooting.

www.precision-repairs.com

Bob

reply »

Small Parts Tips

dual pot selective soldering