Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Mydata TP11 E-stop not released

Views: 575

#85774

Mydata TP11 E-stop not released | 12 October, 2020

TP11 is always showing the error that E-stop is not released. This happens when we start up the machine. It is basically hit and miss, sometimes will work but most of the time this error will pop up. Any suggestions on how to correct this. Is there ay diagnostic page that will tell which e-stop is activated? Thanks

reply »

#85779

Mydata TP11 E-stop not released | 12 October, 2020

Release the e-stops :)

Chances are pretty good that one or more of the e-stop switches is going bad. Pop them off, and measure with an ohm-meter to figure out which one it is, and replace.

I don't recall anything in the software that identified which switch was tripped...as far as I can remember, it's just a signal going into the machine.

Cheers, ..rob

reply »

IPC Training & Certification - Blackfox

Electronics Equipment Consignment