Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


YM-84 Error after power on: 243 Y-AXIS DRIFT ADJUSTMENT NO GOOD

Views: 1309

#85831

YM-84 Error after power on: 243 Y-AXIS DRIFT ADJUSTMENT NO GOOD | 24 October, 2020

Hi, This error popped up while running a panel through the machine. I put the machine into the Drift adjust mode and the y axis was drifting, but not smoothly like the X-Axis was. The Y-axis was drifting but not smoothly. It was more of a jerking motion. I reduced it as much as possible with the trimpot VR17. When I then went to home the machine after reboot, the Y-axis was not smooth and the motion not continuous. Has anyone seen this before and have a possible solution? My guess is that the Y drift is the symptom and not the cause.

Cheers,

Peter

reply »

Micro Mod Auction by the Branford Group

ADJUST-A-VAC Vacuum Tweezer for fragile components, wafers, MEMS devices tweezers