Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Siemens S27HM station software stuckup during "Software Booting"

Views: 1601

#85936

Siemens S27HM station software stuckup during "Software Booting" | 26 November, 2020

Dear All...

Greetings.... Recently My S27HM machine MC had problem and i replaced another same S27HM machine MC and updated BIOS and installed RMOS1&2 after Distribution successfully completed power off the machine and power On the machine, after power cycle station computer still showing "software Booting" no any error displayed on the screen... Checked MC There is one error 'CLI C:/CLISTART>BAT. Again We formeted the MC hard disk and created partation and installed RMOS to MC and After restart same error i'm getting and station software still Booting and nothing is happen. I try to booting with SITES but, if i click any option it is give error massage like "An error(5134, 10, 37, 7) Occurred during communication with MC...

please any know this error kindly help me to run my machine...It is under break down condition..

Regards, Ravi

Attachments:

reply »

#85938

Siemens S27HM station software stuckup during "Software Booting" | 28 November, 2020

Dear all,

kindly help me to solve above issues...

regards, Ragav.....

reply »

#85965

Siemens S27HM station software stuckup during "Software Booting" | 3 December, 2020

Looks like a communication issue to me. IP addresses are wrong or cable/network card is not working

reply »


SMTA-64304333

#85967

Siemens S27HM station software stuckup during "Software Booting" | 3 December, 2020

did you confif the ip/host ad MC ? using the ifconfig command?

This message was posted via the Electronics Forum @ SMTASMTA

reply »

#85969

Siemens S27HM station software stuckup during "Software Booting" | 3 December, 2020

Hi, Ip and mc host both pinging and no issues, but still sitest given communication error, for this i replaced communication card and lan cable as well. But machine software not booting at all...

Regards, Ragav

reply »

SMT Reflow Soldering Equipment Company of the Year 2020!

Manufacturing Software