Excessive Heat / Thermal Excursions From Baking

Subscribe to Thread

Hello Everyone, We are building devices to remove moisture ... - Sep 03, 2021 by Steel Camel

The most common issue with baking parts for removing moistur... - Sep 03, 2021 by Stephen

Hi Stephen, Thanks for reply. Looking for folks who hate b... - Sep 07, 2021 by Steel Camel

Steel Camel

#87013

Excessive Heat / Thermal Excursions From Baking | 3 September, 2021

Hello Everyone, We are building devices to remove moisture from boards prior to rework where it does not require the use of ovens as stated in IPC-TM-650, Method 2.6.28. Instead of evaporation, we use moisture magnets to pull out the part......even diffused moisture. This way we reduce chances of damaging the board and creating pockets for bad thinks to happen. Looking for engineers and tech folks to share their comments on heat damage from excessive baking.

reply »

Stephen

#87014

Excessive Heat / Thermal Excursions From Baking | 3 September, 2021

The most common issue with baking parts for removing moisture too much, is oxidation of the leads. But I haven't seen that too much.

I'm really curious what moisture magnets are and how they work.

reply »

Steel Camel

#87020

Excessive Heat / Thermal Excursions From Baking | 7 September, 2021

Hi Stephen,

Thanks for reply. Looking for folks who hate baking and the problems that come with it. was hoping you can share a little info on what you do and if you use ovens and our desiccant bags made from sand.

thank you,

reply »