MELFs

Subscribe to Thread

Before I waste a lot of time and parts..... Will the Fuji C... - Nov 04, 2002 by Tony

For me it was the 1.0mm nozzle, if we're talking mini-MELF h... - Nov 04, 2002 by PeteC

Thanks, I'll try the 1mm first. So there IS a MELF nozzle? I... - Nov 04, 2002 by Tony

Yeah, there's a MELF nozzle. Check with Fuji or one of the m... - Nov 04, 2002 by PeteC

Hi Check SMT Research, they have nozzles for cp3, 4,6,7 me... - Nov 05, 2002 by rubenh

check out this site ... - Nov 15, 2002 by

Tony

#22259

MELFs | 4 November, 2002

Before I waste a lot of time and parts..... Will the Fuji CP3 place a melf diode without a special nozzle? If so, what size would you reccomend for best accuracy?

reply »

PeteC

#22260

MELFs | 4 November, 2002

For me it was the 1.0mm nozzle, if we're talking mini-MELF here. Also, slowing the turret speed helps. Had mine at 30%. Results vary if placing on paste vs. glue. Paste is better. Still, the std. 1.0mm nozzle is where near as good as with the MELF nozzle. Also, if I didn't have too many on the board and time available on the IP2, I'd move them to the IP2. IP does them very well.

reply »

Tony

#22261

MELFs | 4 November, 2002

Thanks, I'll try the 1mm first. So there IS a MELF nozzle? Iwould try the IP2 but they came on a big reel and I have no feeders for that.

reply »

PeteC

#22263

MELFs | 4 November, 2002

Yeah, there's a MELF nozzle. Check with Fuji or one of the many after-market guys, mostly Asian suppliers. Big reel, no big deal, unravel it and reload in 7" reels.

reply »

rubenh

#22270

MELFs | 5 November, 2002

Hi Check SMT Research, they have nozzles for cp3, 4,6,7 melf custom, Special etc..(805) 587-7851 Just buy the disk, the body is the same and change the nozzle size on (proper) mcs16 or 30

reply »

fujispares

#22417

MELFs | 15 November, 2002

check out this site http://www.fujispares.co.uk

This message was posted via the Electronics Forum @